Users Manual
Table Of Contents
- 1.The Repeater System.1
- 2.Package Contents.2
- 3.Installation.3
- 3.1.Installation of Outdoor Antenna 6
- 3.2.Installation Location Requirement..11
- 3.3.Cable Layout and Connector Assembly14
- 3.4. Switch on the Power15
- 3.5. Check Coverage.15
- 4.Attention.18
- Q5: Phone calls and Internet access are in poor qu
- - A.Adjust the direction of outside antenna and ke
- - B.Re-route the cable from outside antenna to boo
- -C.Verify the distance between outside and inside
- Q6. Cell phone signal is improved but the coverage
- - A.Adjust the angle of inside antenna.
- - B.Verify the place mounting outside antenna rece
- - C.Tighten all cable connections.
- Q7. How to register the booster with Serial Number
- Not all of consumers require to register the boost
- Step 3: Fill in your Location information and Bo
- 空白页面
- 空白页面
- 空白页面
4
Option B：Mount the Indoor Panel Antenna
Installation Steps:
1. Using the plate mark the position of desired screw placement.
2. Screw mounting plate into place with the slide protruding towards up.
3. Hang the antenna securely onto the mounting plate.
4. Connect the antenna short cable to the 15ft cable and run to the planned
location of your booster.
. 5. Place the booster on a flat surface or mounted to a wall and connect
the remaining end of the cable to booster port marked INDOOR.
Note:
1. The Inside Panel Antenna should be facing the area signal is needed and
away from the outdoor antenna (See “Aiming Panel Antenna” below).