Users Manual
Table Of Contents
- 1.The Repeater System.1
- 2.Package Contents.2
- 3.Installation.3
- 3.1.Installation of Outdoor Antenna 6
- 3.2.Installation Location Requirement..11
- 3.3.Cable Layout and Connector Assembly14
- 3.4. Switch on the Power15
- 3.5. Check Coverage.15
- 4.Attention.18
- Q5: Phone calls and Internet access are in poor qu
- - A.Adjust the direction of outside antenna and ke
- - B.Re-route the cable from outside antenna to boo
- -C.Verify the distance between outside and inside
- Q6. Cell phone signal is improved but the coverage
- - A.Adjust the angle of inside antenna.
- - B.Verify the place mounting outside antenna rece
- - C.Tighten all cable connections.
- Q7. How to register the booster with Serial Number
- Not all of consumers require to register the boost
- Step 3: Fill in your Location information and Bo
- 空白页面
- 空白页面
- 空白页面
1
Introduction:
The booster is designed to realize the wireless forwarding and bidirectional
amplifying of the base station’s signal, expand the coverage of communication
signal and cover its blind zone. When booster is working, the outside antenna
(connecting to the OUTDOOR or BTS Port of booster) will receive the cell signal
from signal tower and send the signal to the booster through coaxial cable;
then the booster amplifies the signal and send the boosted signal to the inside
antenna (connecting to the INDOOR or MS Port of booster); finally, the inside
antenna could transmit the signal into your house.
The cell phone signal booster will only make a weak signal stronger,
it can't create a signal. It won't work if the outdoor antenna can't receive any signal.
The outdoor antenna should receive 2-3 bars of stable signal in the location
where the outdoor antenna is fixed; otherwise, the booster won't work very well.
1. THE REPEATER SYSTEM