Users Manual

20
Q4: After finishing the installation, cell phone signal is improved but can’t make a call.
- A.Verify outside antenna is mounted correctly.
- B.Verify the location mounting outside antenna has stable signal,and confirm the
direction of outside antenna is pointed towards to the cell tower.
- C. Verify whether the local operator’s communication frequency is consistent with
booster’s frequency.
Q5: Phone calls and Internet access are in poor quality.
- A.Adjust the direction of outside antenna and keep it point towards the
nearest cell tower.
- B.Re-route the cable from outside antenna to booster (Don't bend the cable
too much, trying to choose straight line).
-C.Verify the distance between outside and inside antennas is over 40 feet
( Too close distance may result in self-oscillating),and there should have wall
isolation between them.It is recommended that inside and outside antennas
don't be mounted on the same horizontal level.
Q6. Cell phone signal is improved but the coverage is unsatisfied.
- A.Adjust the angle of inside antenna.
- B.Verify the place mounting outside antenna receives a strong enough signal.
- C.Tighten all cable connections.
Q7. How to register the booster with Serial Number ?
Not all of consumers require to register the booster . It depends on your area
location requirement. with registration steps for your reference
Step 1: Open the following registration Link given
www.waveform.com/pages/guide-to-signal-booster-registration
Step 2: Find out mobile phone service provider that compatible with your booster.
Click and Enter
Step 3: Fill in your Location information and Booster's Serial Number,
The Serial Number is the FCC ID,(on the label on the back of Booster unit )