Users Manual
Table Of Contents
- 1.The Repeater System.1
- 2.Package Contents.2
- 3.Installation.3
- 3.1.Installation of Outdoor Antenna 6
- 3.2.Installation Location Requirement..11
- 3.3.Cable Layout and Connector Assembly14
- 3.4. Switch on the Power15
- 3.5. Check Coverage.15
- 4.Attention.18
- Q5: Phone calls and Internet access are in poor qu
- - A.Adjust the direction of outside antenna and ke
- - B.Re-route the cable from outside antenna to boo
- -C.Verify the distance between outside and inside
- Q6. Cell phone signal is improved but the coverage
- - A.Adjust the angle of inside antenna.
- - B.Verify the place mounting outside antenna rece
- - C.Tighten all cable connections.
- Q7. How to register the booster with Serial Number
- Not all of consumers require to register the boost
- Step 3: Fill in your Location information and Bo
- 空白页面
- 空白页面
- 空白页面
19
5. Troubleshooting :
Remark:
Increase the output power*---Recommended ways: adjust the outdoor antenna
direction/location, or replace with a higher gain antenna to increase input signal
strength.
You should receive the Mobile Booster kit which
includes the similar above-
mentioned
fittings. Before using it, please confirm that your
Booster’s frequency
range is the same
as your service provider’s network, otherwise,
the amplifier will not
work properly.
Q1: Red Light on Booster Means the Self-oscillating Alarm.
- A. Increase the distance (horizontally or vertically) between the Outside and Inside
antenna; Verify there is wall isolation between them.Unplug and re-plug in power
supply.
- B. Tighten all cable connections (be sure to hand-tighten only, do NOT use
tools).Unplug and re-plug in power supply.
- C. Verify the receiving antenna if be damaged.
- D. Adjust the location of outside antenna.Unplug and re-plug in power supply.
Q2： The booster’s light is not on.
- A.Unplug and re-plug in power supply.
- B.Re-connect the DC12V port on booster
Q3: All lights is normal, but there is not any change with signal strength.
- A.Verify the receiving antenna if be damaged.
- B.Tighten all cable connections (be sure to hand-tighten only, do NOT use tools).
- C.Verify whether the outside and inside antennas connects to correct booster’s port.
- D.Verify whether the booster’s frequency is corresponding with cell phone
frequency.