Users Manual
Table Of Contents
- 1.The Repeater System.1
- 2.Package Contents.2
- 3.Installation.3
- 3.1.Installation of Outdoor Antenna 6
- 3.2.Installation Location Requirement..11
- 3.3.Cable Layout and Connector Assembly14
- 3.4. Switch on the Power15
- 3.5. Check Coverage.15
- 4.Attention.18
- Q5: Phone calls and Internet access are in poor qu
- - A.Adjust the direction of outside antenna and ke
- - B.Re-route the cable from outside antenna to boo
- -C.Verify the distance between outside and inside
- Q6. Cell phone signal is improved but the coverage
- - A.Adjust the angle of inside antenna.
- - B.Verify the place mounting outside antenna rece
- - C.Tighten all cable connections.
- Q7. How to register the booster with Serial Number
- Not all of consumers require to register the boost
- Step 3: Fill in your Location information and Bo
- 空白页面
- 空白页面
- 空白页面
16
Self-excited condition: one or more indicator lights are red.
Warm Reminds: When any one of the band lights jump on Red Status, the booster
device self-oscillating alarm happened. It means the Outdoor antenna is too close to
the Indoor antenna.
Solution: Turn off DC power supply, adjust the outdoor antenna location and height,
try to keep the max. distances between the outdoor antenna and indoor antenna until
the LEDs go back to Green status.
3.5. Check Coverage
(1) Perform a test with a mobile phone or data card Check below:
- A weak input signal leads to the low output power. Need to change the direction
of outdoor antenna or its installation position or replace outdoor antenna with
higher gain antenna to increase input signal power level.
- Check whether it is necessary to add more Indoor antennas’ sine barriers to
- block the signal penetration, and check whether the repeater’s power is enough.
Install more Indoor antennas or replace with a repeater of higher power level.