Users Manual
Table Of Contents
- 1.The Repeater System.1
- 2.Package Contents.2
- 3.Installation.3
- 3.1.Installation of Outdoor Antenna 6
- 3.2.Installation Location Requirement..11
- 3.3.Cable Layout and Connector Assembly14
- 3.4. Switch on the Power15
- 3.5. Check Coverage.15
- 4.Attention.18
- Q5: Phone calls and Internet access are in poor qu
- - A.Adjust the direction of outside antenna and ke
- - B.Re-route the cable from outside antenna to boo
- -C.Verify the distance between outside and inside
- Q6. Cell phone signal is improved but the coverage
- - A.Adjust the angle of inside antenna.
- - B.Verify the place mounting outside antenna rece
- - C.Tighten all cable connections.
- Q7. How to register the booster with Serial Number
- Not all of consumers require to register the boost
- Step 3: Fill in your Location information and Bo
- 空白页面
- 空白页面
- 空白页面
11
Plug the Power Supply into wall outlet then connect to Booster.The minimum distance
between outdoor antenna and indoor antenna shall be more than 39ft, again.
The repeaters should be used to cover the indoor area.Humidity and temperature of
working environment can affect the reliability of repeater. so, temperature, humidity, dust,
interference, power, space requirements and other factors should be considered during
installation of repeater.
3.1 Installation Location Requirement
（1） It is important that the repeater is installed in a place where is away from excessive
heat, direct sunlight, moisture and with proper ventilation. Do not place the repeater in
an air-tight enclosure.
（2） Installation height should be easy for RF cable wiring, heat dissipation, security and
maintenance.
（3） There should be an independent and stable power supply.
（4） Lightning protection is recommended for all in-building installations. Take extreme
care to ensure neither you nor the antenna come in contact with any electrical power
lines. stability.