Users Manual
Table Of Contents
- 1.The Repeater System.1
- 2.Package Contents.2
- 3.Installation.3
- 3.1.Installation of Outdoor Antenna 6
- 3.2.Installation Location Requirement..11
- 3.3.Cable Layout and Connector Assembly14
- 3.4. Switch on the Power15
- 3.5. Check Coverage.15
- 4.Attention.18
- Q5: Phone calls and Internet access are in poor qu
- - A.Adjust the direction of outside antenna and ke
- - B.Re-route the cable from outside antenna to boo
- -C.Verify the distance between outside and inside
- Q6. Cell phone signal is improved but the coverage
- - A.Adjust the angle of inside antenna.
- - B.Verify the place mounting outside antenna rece
- - C.Tighten all cable connections.
- Q7. How to register the booster with Serial Number
- Not all of consumers require to register the boost
- Step 3: Fill in your Location information and Bo
- 空白页面
- 空白页面
- 空白页面
8
Option D: Mount the Omni-directional Antenna
Installation Steps:
1.Assemble the u-bolt, bracket, nuts and washers onto a mast (not
provided) as shown in the illustration.
2.Connect one end of the provided coax cable to the antenna and
tighten the connection.
Note
:
1.The Omni Antenna receives and sends signals in a 360-degree
radius. Mount the antenna at the highest possible elevation and in
an upright position.
2.Ensure that the entire outside antenna is above the roof
line of the building and is at least 12 inches away from any
metal obstructions and other radiating elements.
3.The minimum distance between outdoor antenna and indoor antenna
shall be more than 39ft; and the direction of outdoor and indoor antennas
shall be opposite.