Users Manual
Table Of Contents
- 1.The Repeater System.1
- 2.Package Contents.2
- 3.Installation.3
- 3.1.Installation Location Requirement.14
- 3.2.Installation of Outdoor Antenna.15
- 3.3.Cable Layout and Connector Assembly17
- 3.4. Switch on the Power18
- 3.5. Check Coverage.18
- 4.Attention.20
- Q5: Phone calls and Internet access are in poor qu
- - A.Adjust the direction of outside antenna and ke
- - B.Re-route the cable from outside antenna to boo
- -C.Verify the distance between outside and inside
- Q6. Cell phone signal is improved but the coverage
- - A.Adjust the angle of whip antenna.
- - B.Verify the place mounting outside antenna rece
- - C.Tighten all cable connections.
- Q7. How to register the booster with Serial Number
- Not all of consumers require to register the boost
- Step 3: Fill in your Location information and Bo
17
3.3 Cable layout and connector assembly
Connect cables to the booster’s ports after installing and fixing outside and inside
antennas.Steps as below:
（1）Open the cable package and make it bend naturally and smoothly.
（2） Keep horizontal cables straight and fasten them with a fixing clip every 1 to 1.5
meters.
（3）The cable should be bent naturally and smoothly to avoid cable damage caused by
strong pulling.
（4）RF cables should be sepa
ra
ted from power cables; If the site condition are limited,
installing RF cables and power cables together may affect product performance.
（5）Tighten all cable connections to ensure a good contact.
（6）Offer waterproof treatment to the exposed cable ends to avoid oxidation.
（7）Finish the cable layout
At last, plug the Power Supply into wall outlet and enjoy
your boosted cell signal!
The Specification of Boosters’ Ports:
Port Name
Port Description
DC12V
12V Input
OUTDOOR/BTS
The reception of base station downlink signal, and
the
transmission of cell phone uplink signal
INDOOR/MS
The transmission of base station downlink signal, and
the reception of cell phone uplink signal