Users Manual
Table Of Contents
- 1.The Repeater System.1
- 2.Package Contents.2
- 3.Installation.3
- 3.1.Installation Location Requirement.14
- 3.2.Installation of Outdoor Antenna.15
- 3.3.Cable Layout and Connector Assembly17
- 3.4. Switch on the Power18
- 3.5. Check Coverage.18
- 4.Attention.20
- Q5: Phone calls and Internet access are in poor qu
- - A.Adjust the direction of outside antenna and ke
- - B.Re-route the cable from outside antenna to boo
- -C.Verify the distance between outside and inside
- Q6. Cell phone signal is improved but the coverage
- - A.Adjust the angle of whip antenna.
- - B.Verify the place mounting outside antenna rece
- - C.Tighten all cable connections.
- Q7. How to register the booster with Serial Number
- Not all of consumers require to register the boost
- Step 3: Fill in your Location information and Bo
7
Step 2 : Install the Outdoor Antenna
The directional Yagi, Panel or LPDA Antenna should be mounted at the
highest possible location above the roof line ‒ at least 25 feet above the
indoor antenna ‒ aimed in the direction of your nearest carrier’s cell tower.
To find the location of your closest carrier’s cell tower, Or adjust the direction of the
outdoor antenna according to the location of the cell tower of the different mobile
phone operator used
go to www.antennasearch.com.
Ensure that the mounting area has at least a 12 inches radius clear of
obstructions, other radiating elements and metal objects such as pipes or
metal siding. Once you have identified your install location,
assemble the u-bolt, bracket, nuts and washers onto a pole
(available separately) as shown in the illustration. Keep the connections loose
enough to allow the antenna to rotate until the optimum direction is found.
Run the cable along route to planned location of your booster.
Option A: Mount the Directional Outdoor Panel Antenna
Find a best signal place at a high location outdoor.
Installation Steps:
1. Attach the L-Bracket to the Outside Panel Antenna and use the U-
Bolts/Pole Bracket to attach the L-Bracket to a pole.
Let the peak of Panel antenna pointed to the cell tower.