User's Manual

P a g e | 5
Need Help? Get FREE USA-based technical support direct from PalmVID
Call 800-618-7491 or email [e-mail]
Powering the Device
Before starting the setup procedure, power the device.
Constant AC Power with Battery Backup
Battery Power
Connect USB charger and cable to the
device (see illustration on page 4 to find
the correct port) and plug the USB
charger into a wall outlet.
To connect the battery to the camera,
plug the red connector of the battery
into the red connector on the camera.
After plugging in the battery and/or USB power cord to the camera, the camera
will show a faint red and/or blue light from a hole near the Micro SD card slot. If
this light does not appear, check all power connections, and check to make sure
the battery is charged.
Charging the Battery
1. Disconnect the battery from the battery connector
2. Plug the battery into the fast charger (below)
3. Connect the Wall Charger to a power outlet
4. While charging, the charger will show a red light. When the battery is done
charging, the red light will turn green; this indicates that the battery is fully
charged. Normally this takes 4-6 hours.