Quick Start Guide
Taking o / Landing
1. Auto take-o: press the take-o / land button when the aircraft is
ready. The aircraft will hover at 1.2m altitude after take-o.
2. Manual take-o: Push both sticks to the bottom outer corners to
start the motors. Move the throttle stick up to command the aircraft to
take o and hover at 1.2m altitude.
Take o
Auto land:
Press the take-o / land button while the aircraft is in the air, the aircraft
will start to descend at a vertical speed of 2.5 m/s when the altitude is
above 10m, or at 0.6 m/s when the altitude is below 10m. Auto landing
can be canceled anytime by moving the throttle stick up unless the
battery level is down to level 2 warning. Or it can also be canceled by
pressing the take-o / land button again.
Land
Adequate lighting and grounds with clearly visible textures are
required.
B. GPS mode: Enabled when aircraft receives suciently strong
satellite signal with adequate positional accuracy. The app will give a
prompt when the aircraft enters GPS mode, while the aircraft tail light
becomes solid.
C. Attitude mode: Under poor GPS signal and ground visibility, the
aircraft will enter attitude mode. The aircraft will keep itself level, but
its position will not be xed at one point automatically. Manual control
is needed to keep the aircraft in a xed position.
Manual land:
Reduce the throttle gently to manually land. The maximum descend rate
is 2.5 m/s until the altitude is reduced to 1m. When the altitude is less than
1 m, the vertical speed is reduced to 0. Next, keep the throttle low for 3
seconds to trigger auto land.
Forced land:
When the battery is critically low, the aircraft will be forced to land. Forced
landing cannot be canceled by any means.
23