User's Manual

831 USER MANUAL
30
(OFF
Ethernet is disabled
by the user or the
network cable is not
connected or
Ethernet card
hardware failure
1. Users press RESET 5 seconds to
restore the factory settings.
2. Check \ replace the camera and
connect the network cable between
the routers.
3.
Camera hardware failure, requiring
repair.
Red light
Network cable is
connected, the IP
address is obtained
1. Please make sure your routers
DHCP server is enabled.
2. Try to restart the router.
3. Manually assign a letter to the
Ethernet IP address of the router the
same gateway.
Flashing
red
IP address has been
obtained or the user
to configure a static
IP address, is trying
to communicate with
the gateway
1. Confirm whether the router is good.
2.
Camera hardware failure, requiring
repair.
Green
light
And gateway
communication is
normal, is trying to
communicate with the
internet
1. The user to check whether the
network can access the Internet.
2. Check whether there are two
routers connected (first level router
network cable will need to receive a
second-class router's WAN port on
the job).
3. Check the router is turned on the
firewall to do MAC address filtering.
STATE2/STA2
(
)
Green
flashing 2
times
Internet traffic is
normal, is trying to
communicate with the
cloud server
1. Restart the machine or the
machine on again to restart.
2.
Try running the machine,
based on the press machine
base RESET button hole 6
seconds, set the machine to
restore the factory tune.