User's Manual

831 USER MANUAL
28
indicator) hardware failure, requiring repair.
(OFF
Wifi was disabled by
the user or wifi
hardware failure
1. Press RESET for 5 seconds to
restore the factory settings.
2.Make camera with wired Ethernet
connection, after landing, in the
"Manage" -> "Network" ,make WIFI
enabled;
3. Camera hardware failure, requiring
repair.
Red light
Normally on
WIFI router is trying
to connect
1. Verify WIFI router is good;
2. Try the camera placed from
somewhere near WIFI router and
then reconnect the power.
3.
Restart WIFI routers and cameras;
4.
Camera hardware failure, requiring
repair.
Red
Flashing 2
times
Is connected to the
router, is trying to
obtain an IP address
through DHCP
1. Please make sure your router's
DHCP server is enabled.
2. Try to restart the router.
3.
Manually assign a WIFI router to
the same gateway IP address.
Red light
flashing 3
times
Ip address has been
obtained or the user
to configure a static ip
address, is trying to
communicate with the
gateway
1. Confirm the router is good.
2. Camera hardware failure, requiring
repair.
STATE1/STA1
(
)
Green
light
Normally on
And gateway
communication is
normal, is trying to
communicate with the
internet
1. User can check whether the
network can access the Internet.
2. Check whether there are two
routers connected (first level router
network cable will need to receive a
second-class router's WAN port on
the job).