User's Manual

A. for use of speed light flash
1) Put 2 AAA batteries into the receiver and close the battery cover
2) Plug the flash into the receiver’s hot shoe socket, and fix it; turn on the power of
receiver and flash
3) Set the channel selectors of both transmitter and receiver at same position, and
transmitter can send signal to receiver to trigger the flash
B. for use of studio flash light
1) Put 2 AAA batteries into the receiver and close the battery cover
2.) You can use the 3.5mm PC (with 6mm converter) Sync cord to connect the receiver
and studio light to trigger the studio light.
3) Set the channel selectors of both transmitter and receiver at same position, and
transmitter can send signal to receiver to trigger the studio flash
6. Notice of usage
1) Use batteries specified in this user guide, and to replace a new battery if the receiver’s
signal LED becoming dim.
2) Prevent the unit from falling and crushing.
3) Keep the unit dry, and avoid electric shock, rain and dampness.
FCC ID: XBYPT0402RX
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY
TO OPERATE THE EQUIPMENT.
Contact Tel : [phone]
Contact Fax : [phone]
E-Mail: [e-mail]