User's Manual

8. Using a Phottix Atlas transceiver in hand will allow for remote wireless shutter
release functions. The Atlas test button will work as a single-stage shutter button
– one press will autofocus the camera and take a photo.
Consult the instructions included with your Phottix Atlas Shutter Release Cable
for specifics.
* On compatible cameras
Using the Atlas as a wireless remote with more than one camera *
Phottix Atlas transceivers can trigger multiple cameras when used as a wireless
remote.
1. Turn off the camera and the Phottix Atlas transceiver.
2. Attach the correct Phottix Atlas Shutter Release Cable for your camera
make and model to the Flash In/Out Port on the transceiver.
3. Attach the other end of the cable to the camera’s remote port.
4. Turn on the camera and Phottix Atlas transceiver.
5. Repeat steps 1-4 for additional cameras, making sure the Atlas
transceivers attached to the cameras and the transceiver to be used a
wireless remote are set to the same channel. **
6. Position cameras.
7. Using a Phottix Atlas transceiver in hand will allow for remote wireless
shutter release functions. The Atlas test/shutter button will work as a
single-stage shutter button – one press will autofocus and take a photo.
8. Pressing the test/shutter button will take photos on all cameras attached to
Phottix Atlas transceivers
Consult your camera manual for specific settings for remote use.
* On compatible cameras
** WRS Mode may not work correctly when multiple cameras and flashes are
used.
Transmitter Only Mode
The Atlas transceiver can be set to only transmit signals, not receive them. This
is useful when more than one photographer is using WRS Mode on the same
channels.
To turn on Transmitter Only Mode:
1. Turn off the Atlas transceiver
2. Press the Test / Shutter button while turning the Atlas back on.
3. The Status light will blink green – twice as fast as it does in regular
transceiver mode.
To turn off Transmitter Only Mode:
1. Turn off the Atlas transceiver
2. Turn the Atlas transceiver back on – it will start in regular transmit /
receiver mode.
Using with Sekonic Light Meters