Robotic vacuum cleaner Model: R342 Operation Manual
Important Safety Instructions • Before using this device, pick up objects like clothing and loose paper. Lift up cords To reduce the risk of injury or damage, read these safety instructions carefully and for blinds or curtains, and move power cords and fragile objects out of the way. If this device passes over a power cord and drags it, an object could be pulled off a table or shelf.
WARNING 1、This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance.
FCC Radiation Exposure Statement: The transmitter must not be colocated or operated in conjunction with any other antenna or transmitter. This equipment complies with the FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and any part of your body. FCC Warning This device complies with Part 15 of the FCC Rules.
Contents Product Composition / Package Contents 6 Product Composition / Part Name 7 LED Display Function 8 Dust Box, Water Tank and Charging Dock 9 Product Usage / Preparation 10 Product Use/ Robot Chariging 11 Product Usage / Select a Cleaning Mode 12 Time Scheduling Setting 13 Mopping / Water Tank 14 Cleaning and Maintenance 15 Troubleshooting 16 Product Parameter 17 5
Product Composition / Package Contents Robot Charging Dock AAA Battery Remote Handset Power Adapter Cleaning Brush Instruction Manual Side Brush X4 HEPA Filter X2 Water Tank Mopping Cloth Dust Box 6
Product Composition / Part Name Robot back view Drop Sensor Magnetic Sensor Side Brush Drive Wheel Dust Box Charging Contact Pins Omnidirectional Wheel Battery Compartment Rolling Brush Brush Guard Dust Box 7
LED Display Function LED ICONS Function Description Edge cleaning mode: icon always light up, start cleaning; icon flashing, cleaning pause Auto cleaning mode: icon always light up, start auto cleanin; icon flashing, cleaning p ause Single room mode: icon always light up, start single room cleaning; icon flashing clea ning pause Spot mode: icon always light up, start intensive cleaning in the selected area; icon fla shing, cleaning pause.
Dust Box, Water Tank and Charging Dock Dust Box Charging Dock Signal sensor High Efficiency Strainer High Efficiency Top Cover Primary Filter Strainer Dust Box Metal Sheet Vent DC socket Dust Box Swivel Cover Water Tank and Mopping Cloth 10 DC socket
Product Usage / Preparation Before using the Robot, remove the protective strip on the Robot and Charging Dock Remove Protection 11
Product Usage / Robot Charging Place the Charging Dock on a hard, level surface and against a wall. Remove objects within 1.5 ft/0.5 m on both sides and within 3 ft/1 m in front of the Charging Dock. C W C D N L 5 Robot returns to the Charging Dock at the end of a cleaning cycle or when its battery is running low Plug the adapter into the a wall outlet and plug the DC jack into the DC socket of the Charging Dock.
Product Use / Select a Cleaning Mode 1. Auto Cleaning Robot optimizes its cleaning path by selecting different cleaning modes automatically until cleaning is complete. This is the most commonly used cleaning mode. Press on the Robot or start cleaning in Auto Mode / H on the Remote Handset to D T - Robot will return to the Charging Base automatically when the battery level becomes low or when Robot is finished cleaning. - By default, Robot starts in Auto Cleaning mode when it is turned on.
Product Use / Select a Cleaning Mode 6. T -Make sure the time is set correctly to your local time before setting a scheduled cleaning.
Mopping / Water Tank Do not use mopping function with any carpet floor Please remove mopping cloth and clean it after mopping is completed. Please empty the water tank after each use.
Cleaning and Maintenance B x D Robot Part Cleaning Frequency Replacement Frequency Filters Once every week Every 2 months Rolling Brush Once every week Every 6-12 months Side Brushes Once every month Every 3-6 months (or when visibly worn) Brush Guard Once every month Every 3-6 months (or when the silicone rubber strip on the brush guard becomes visibly worn) Sensors Once every month Charging Pins Once every month Swivel Wheel Once every month x D D 16 x x
Cleaning and Maintenance T -It is recommended to clean the primary strainer with water every 15 - 30 days after been used. The use life of the high efficiency filter screen is 3 months. 1. Before installing the filter screen, please ensure that the high efficiency filter screen and the primary filter screen are dry. 2. Do not expose the high efficiency strainer and primary strainer into the sun.
Cleaning and Maintenance Water Tank and mopping cloth care W W 4U 5D W v W 18
1 2 3 4 5 1 2 4 5 3 T 19 Only use the side brushes when completely dried.
please use dry dishcloth for cleaning, and do not use wet dishcloth to prevent damage caused by water.
Warnings about battery You must not remove (or attempt to remove) the battery incorporated in this product on your own. To replace the battery, you must contact your service provider or an independent qualified professional. These instructions have been prepared for the exclusive use of your service provider or independent qualified professional. WARNING FOR YOUR OWN SAFETY, DO NOT ATTEMPT TO REMOVE THE BATTERY ON YOUR OWN OR DISPOSE OF IT IN FIRE. DO NOT DISASSEMBLE, CRUSH OR PUNCTURE THE BATTERY.
Correct disposal of batteries in this product (Applicable in countries with separate battery return systems.) The marking on the battery, manual or packaging indicates that the battery in this product should not be disposed of with other household waste. Where marked, the chemical symbols Hg, Cd or Pb indicate that the battery contains mercury, cadmium or lead above the reference levels in EC Directive 2006/66. The battery incorporated in this product is not user replaceable.
Troubleshooting No. Prompt Tone Cause of Failure Solution 1 Wheels off the ground Robot suspended Please put the Robot back to the ground and press the cleaning key again. 2 Dust Box not installed Dust box removed and not installed Return the dust box to the Robot and press the cleaning key again. 3 Battery failure Abnormal battery charging Contact our customer service department to test battery.
Classification Structural class Battery parameter Projects Parameter Diameter 330 mm / 1.08 ft Height 74mm / 0.25 ft Net weight 2.7 kg / 5.94 lbs Voltage 14.8 volts Battery 3000 mAh rechargeable lithium battery pack Dust box capacity 600 ml Charging type Automatic charging / Manual charging Cleaning mode Auto / Single Room / Edge / Spot / Mopping Primary charging time About 300 minutes Working time About 150 minutes Rated power (w) 28w Operating voltage ( v ) 14.
Component Pb/Pb compound Hg/Hg compound Harmful Substance Cd/Cd compound Cr(VI)Cr(VI) compound PBB Plastic Hardware Host circuit module Electronic Battery Plug power cord (Metal part) Description: This form is prepared in accordance with the provisions of SJ/T 11364. : Indicates that the content of the hazardous substance in all homogeneous materials of the part is below the limit requirement specified in the current valid version of GB/T26572.
Comply with standard ETSI EN 300 328 V2.1.1 (2016-11) Draft ETSI EN 301 489-1 V2.2.1 (2019-03) Draft ETSI EN 301 489-17 V3.2.0 (2017-03) EN 55014-1:2006/A1:2009/A2:2011 EN 61000-3-2:2014 EN 61000-3-3:2013 EN 55014-2:2015 EN 62311:2008 EN 60335-2-2:2010+A11:2012+A1:2013 in conjunction with EN 60335-1:2012+A11:2014+A13:2017 EN 62233:2008 Manufacturer: Shenzhen Free Dynamics Development Co., Ltd. IM Download Please download the IM through our website: Web.: www.freedynamics.
