User's Guide

Notice:

Install the battery according to the specified direction, and do not mix old and new batteries.

Incorrect installation of the battery will not power on the camera and may damage the camera or risk.

After installation, the latch must be fastened, otherwise water or dust will damage the camera.

2.3 Using external power supply

The camera can be powered by an external power supplies.

2.3.1 Install the batteries, toggle the【Function switch】to the appropriate gear, close the face cover, and

hold the latch tight.

2.3.2 Remove the waterproof glue plug from the camera DC IN interface and plug the external power

supply into the camera DC IN interface.

2.3.3 Access the power source, the camera will automatically switch to the external power source after

detecting the external power source.

Insert the DC-IN interface of the power adapter

Notice:

Please make sure to use the standard external power supply with specification: output DC12V/2.0A. Cover

the waterproof adhesive plug without using the external power supply.

2.4 Installation and fixation of camera

To ensure the camera works safely, install the camera in a firm place，users can secure the camera by

using a strap or bracket.

2.4.1 Installation with a strap

Use the strap through the back hanging hole of the camera, and then fasten the strap to a tree or other firm

object, adjust the shooting angle of the camera and tie the strap. The figure is shown below:

Bandag