User's Manual

www.foscam.com
Shenzhen Foscam Intelligent Technology Co., Limited
Tel: [phone] Fax: [phone]
49
Step 3: Wait around 10 seconds, you’ll see that the camera’s IP address has changed. In our example it
was changed to 2000, so we see http://192.168.8.102:2000 in IP Camera Tool. Also, the IP address is
now fixed at a static IP address of http://192.168.8.102:2000. This IP address will not change even if the
camera is powered off and back on, the camera will remain on this IP address. This is very important that
a static IP address is set, or you may have problems later with remote access and seeing the camera
remotely if the camera loses power and reconnects on a different IP address. Make sure you set a static
IP address!
Note: Http port and Https port must be different.
If the camera cannot be accessed, please make sure the port forwarding is succeed.
4.4.7 Mail Settings
If you want the camera to send emails when motion has been detected, here Mail will need to be
configured.
1---- SMTP Server/ Port /Transport Layer Security Enter SMTP server for sender. SMTP port is
usually set as 25. Some SMTP servers have their own port, such as 587 or 465, and Transport Layer