User's Manual

www.foscam.com
Shenzhen Foscam Intelligent Technology Co., Limited
Tel: [phone] Fax: [phone]
10
Note:
64-bit browser is not supported.
2.1.2 WPS (WI-FI Protected Set-up)
Before using WPS wireless connection, you need to:
Make sure that your wireless router has the WPS function, and has been properly connected to the
Internet. WPS button on the wireless router is typically located on the front panel or rear panel. TP-LINK
router's WPS button is called QSS (Quick Security Setup).
(1) Press and hold the WPS button for three seconds. The blue indicator on the side of the camera
begins to twinkle at high frequency. (You can press and hold this button for more than 10s to reset
the camera. After the reset, the settings of the camera are restored to factory defaults.)
(2) Press and hold the WPS button for three seconds on your wireless router within 60 seconds. Then
the camera will automatically create a secure wireless connection to your router in about 60
seconds.
2.2 Access the FosBaby in WLAN
First of all, you need to connect the camera to your wireless router.
2.2.1 Static IP Addresses
Users who have static IP addresses do not need to set DDNS service settings for remote access. When
you have finished connecting the camera using the IP address and port forwarding, you can access the
camera directly from the Internet using the WAN IP address and port number.
How to Obtain the WAN IP address from a public website ？
To obtain your WAN IP address, enter the following URL in your browser: http://www.whatismyip.com.
The web page at this address will show you the current WAN IP.