User's Manual

www.foscam.com
Shenzhen Foscam Intelligent Technology Co., Limited
Tel: [phone] Fax: [phone]
58
To enable motion detection, follow the steps below:
1 Enable Motion detection
2 Sensitivity---- It supports three modes: Low, Middle and High. The higher the sensitivity, the camera will be more
easily alarmed. Select one motion sensitivity.
3 Trigger interval--- The interval time between two motion detections. Here supports
5s/6s/7s/8s/9s/10s/11s/12s/13s/14s/15s. Select one interval time.
4 Select the alarm indicators
There are three alarm indicators:
A Ring
There is an embedded speaker inside the camera, so if you select Ring, when the motion has been detected, the people
around the camera will hear beep alarm sound.
B Send E-mail
If you want to receive alarm emails when motion is detected, you must select Send E-mail and set Mail Settings first.
The alarm email cannot contain the alarm picture if you have not selected Take Snapshot.
C Take Snapshot
If you select this checkbox, when the motion has been detected, the camera will snap the live view window as a still
picture and load it to the FTP. Make sure you have set FTP and set FTP as the storage path in Video->Snapshot settings
panel.
If you select Send Email, at the same time the picture will be send to you as an attachment.
Capture interval: The interval time between two pictures.
Step 05: Set detect area
Click set detect area and it pop up a window, then you can draw the detection area. Click Back button after settings.
When something moving in the detection area, the camera will alarm.