User's Manual

74
74
readme.txt file. If not, please download the firmware again until the sizes are the same. Your camera will
not function correctly if a corrupt .bin file is used.
4) Normally, only Device WEB UI need to be upgrade, please do not try to upgrade the Device System
Firmware.
5) Never shut down the power of the camera during upgrade until the IP camera restart and get connected.
6) After upgrade successfully, please uninstall the old plugin and re-install it, then reset the camera to the
default factory settings before using the camera.
4.9.3 Patch Installation
Click "Browse" to select the correct patch file, and then click "Install Patch" to install the patch. Do not turn off
the power during it installing. After installing is complete, you will receive a system prompt.
4.9.4 Factory Reset
Click All reset and all parameters will return to factory settings if selected. This is similar to press the Reset
button on the bottom of the camera.
Figure 4.78
4.9.5 Reboot
Click Reboot System to reboot the camera. This is similar to unplugging the power to the camera.
Figure 4.79