User's Manual

Shenzhen Foscam Intelligent Technology Co., Limited
Tel: [phone] Fax: [phone]
4
Rear panel:
 Power Light: If the power supply works fine, the light will be on.
 LAN: 10/100 Mbps RJ-45 port for wired connection
 SoftAP: Press the SoftAP button for more than 2 seconds. The Network light indicator begins to
twinkle every 0.1 seconds.
 WPS/Reset
 WPS: Push both WPS/Reset button on the camera and wireless router within 1 minute, the
camera will connect to the wireless router automatically, in WPS process, the Network light will
blink every 0.4 seconds;
 Reset: Push and hold the WPS/Reset button for more than 10 seconds to set the camera to
factory default, the Power light will blink every 0.4 seconds;
 Power: DC 5V/1A Power supply.
The flashing status of the Power light and Network light are shown in the following table.
Light Flashing Status Description
Power light off The power don't work properly.
on The power supply works fine.
Flashing every 0.4 seconds Reset to take effect
Network light off No Wireless connection
Constant Wired connection
Slow Flash once per second Wireless connection
Flashing every 0.4 seconds WPS is connecting
Flashing every 0.2 seconds EZLink takes effect
Flashing every 0.1 seconds SoftAP is started
2 Access the IP Camera
2.1 Wired Connection
1. Connect the camera to the LAN network (Router or Switch) via network cable.