User's Manual

6.5 After the Z-axis descends and stops, gently press on top of the platform with your
hand, to let it fit evenly on the 2K LCD screen and ensure that the printing platform is
parallel to the LCD screen. Then fix the set screw as tight as possible; as shown in
picture (6.6)
6.6 The platform rises about 120mm, click on the operation screen <Return>-<Next>-
<Exposure>-<Next> to check whether the light source is working normally, as shown
in picture (6.7); The 2K screen should display the same as the picture below the image
indicates that the UV lights work perfectly; as shown in picture (6.8)
6.7 Before putting it in the resin vat, please make sure the release film is tight. If the
release film is not tight, please tighten the screw on the bottom of the resin vat to fix
the release film; then follow the steps in the figure below to install it. Put the resin vat
back and fasten the press buckles on both sides to complete the leveling. (as shown in
picture 6.9&6.10)
Picture (6.7) Picture (6.8)
Click here to
change the
detection
exposure time
Picture (6.10)Picture (6.9)
7
Picture (6.6)