User's Manual

6. Assembly and Leveling Instructions
6.1 Connect power cable to printer and power supply; as shown in picture (6.1)
6.2 Click on the operation screen <Settings>-<Move Z>, select <10mm> travel and
click to rise the Z axis. Check and keep the LCD screen and the platform clean and free
of debris; as shown in picture (6.2)
6.3 Loosen the set screw on the printing platform with an Allen wrench so the platform
can be rotated freely. Install the platform onto the platform bracket and push it to the
end. Lastly tighten the platform securing knob on the top; as shown in picture (6.3)
6.4 Click“HOME”, wait for the Z axis to descend and then it will stop automatically; as
shown in picture (6.4＆6.5)
Picture (6.1)
Picture (6.2)
Picture (6.3)
Power interface
Power switch
Picture (6.4)
6
10mm
:
:
10mm
Platform Securing Knob
Fastening screw
②
①
Picture (6.5)