User's Manual

Picture (38)

8. First printing instructions

In order to avoid the first printing failure, please check steps below again before print-

ing:

(1) Whether the Z axis works normally;

(2) Whether the print platform is attached enough to the LCD screen;

(3) Whether the UV light source is displayed normally;

8.1 Print model

8.1.1 Wear a mask and gloves, slowly pour resin into the resin vat to about 1/3 of the

height of the resin vat ( Kinkly note that the resin cannot directly touch the skin, and

the maximum position pf resin does not exceed 1/2 of the resin vat depth); as shown in

picture (37)

8.1.2 Select <Print>-<Select File>-<Start Printing>; as shown in picture (38)

Picture (37)