User's Manual

3.7.3 Automatic support ( refresh data, collapse, expand): Set the data of
automatic support, there is a default value, and the user can change it according to his
preference.as shown in figure (7.27)
(1) can automatically add support to the model (support is not generated
on the model, as shown below);
(2) can automatically add support to the model (support is also generated
on the model, as shown below);
3.7.4 Add support: manually add support at any position on the model;
3.7.5 Delete support: manually delete the existing support at any position
on the model;
3.7.6 Edit support: manually edit the existing support at any position on the
model;
3.7.7 Remove all: remove all existing supports;
3.8 printing process
3.8.1 Model selection: In the slice setting, click to pop up; (If your mac-
hine is not in the list, you can select Default and set the parameters yourself.)as shown
in figure (7.28)
Figure (7.27)
Figure (7.28)
21