User's Manual

(5) Gcode setting interface; as shown in figure (7.21)

<Start>: preprocessing command executed at the start of printing (can be customized);

<Interlayer>: Processing commands executed by each layer during printing (can be customized);

{image} The name of the exposure image generated;

{raise_pos} corresponds to the lifted position, it is an absolute coordinate value, value = exposure

position + lifted height;

{raise_speed} is the lifting speed, lifting speed = bottom lifting speed or lifting speed;

{fall_pos} corresponds to the position of fall, it is an absolute coordinate, value = exposure position;

{fall_speed} is the falling speed, the falling speed = the bottom falling speed or the falling speed;

{exposure_time} corresponds to the bottom exposure time or exposure time, the unit is ms;

<End>: Processing command executed at the end of printing (can be customized);

{machine_height} corresponds to the height of the machine size;

Figure (7.21)