User's Manual

For example, the period of the Z axis moving up and down is 6 seconds:

If the "light-off delay" is set to 10 seconds, the final turn-off time is 10 seconds;

If the "light-off delay" is set to 1 second, the final light-off time is 6 seconds;

<Bottom light-off delay>: The light-off delay time of the bottom layers is calculated in

the same way as above;

<Bottom layer lifting distance>: the distance the molding platform is lifted when

printing the bottom layers;

<Lifting distance>: the distance the forming platform is lifted during normal layer

printing;

<Bottom lifting speed>: the speed at which the forming platform lifts when printing

the bottom layers;

<Lifting speed>: the speed at which the forming platform is raised during normal layer

printing;

<Return speed>: the speed at which the forming platform descends;

(4) Fill the setting interface; as shown in figure (7.20)

<Filling structure>: Selection of filling type inside the model, such as mesh structure, etc.;

Figure (7.20)