User's Manual

(2) Resin setting interface; as shown in figure (7.18)

<Resin type>: Different resin types have different parameters, some resins recommended by integrated

companies and corresponding parameters;

<Resin density>: Density of resin, used to calculate mass;

<Resin price>: The cost of resin, used to calculate the cost;

(3) Print setting interface; as shown in figure (7.19)

<layer thickness>: The thickness of each layer of the model is generally 0.025/0.05/0.1mm;

<Number of bottom layers>: The number of layers to be solidified at the bottom of the model.

In order to better stick to the platform, the parameters of the bottom layer need to be set

separately;

<exposure time>: exposure time of normal layer;

<Bottom layer exposure time>: the exposure time of the bottom layers, the general time will

be longer than the normal layer exposure time, let the resin cure as completely as possible, to

ensure that it sticks to the molding platform;

<Light-off delay>: Calculated from the end of the exposure of the previous layer, the final

light-off time = maximum (the total time of the Z axis moving up and down, the configured

light-off delay)

Figure (7.18)

Figure (7.19)