Operation Manual
Table Of Contents
- 5 -
Figure4
Optional Sensors（Purchased separately）
PM2.5/PM10 air quality sensor: Soil Moisture Sensor:
Installation
Before placing and installing all components of the weather station at their final destination, please set up the
weather station with all parts being nearby for testing the correct function. Also please note configuring
parameters on PC software is necessary before permanent installation. (Refer to
USB Configure Tool
Operation part).
Outdoor unit
1. Install U-bolts and metal plate
Installation of the U-bolts, which are in turn used to mount the sensor package on a pole, requires installation of
an included metal plate to receive the U-bolt ends. The metal plate, visible in Figure 5 has four holes
through which the ends of the two U-Bolts will fit. The plate itself is inserted in a groove on the bottom of
the unit . Note that one side of the plate has a straight edge (which goes into the groove), the other side is
bent at a 90-degree angle and has a curved profile (which will end up “hugging” the mounting pole). Once
the metal plate is inserted, insert both U-bolts through the respective holes of the metal plate as shown in
Figure 3.