Operation Manual

- 38 -
Problem Solution
panel to drain the voltage.
Put batteries back in and resync the console with the sensor array
about 10 feet away.
The LED next to the battery compartment will flash every 16 seconds.
If the LED is not flashing every 16 seconds…
Replace the batteries in the outside sensor array.
If the batteries were recently replaced, check the polarity. If the sensor
is flashing every 16 seconds, proceed to the next step.
There may be a temporary loss of communication due to reception
loss related to interference or other location factors,
or the batteries may have been changed in the sensor array and the
console has not been reset. The solution may be as simple as
powering down and up the console (remove AC power and batteries,
wait 10 seconds, and reinsert AC power and batteries).
Temperature sensor
reads too high in the
day time.
Make certain that the sensor array is not too close to heat generating
sources or strictures, such as buildings, pavement, walls or air
conditioning units.
Use the calibration feature to offset installation issues related to
radiant heat sources.
Relative pressure
does not agree with
official reporting
station
You may be viewing the absolute pressure, not the relative pressure.
Select the relative pressure. Make sure you properly calibrate the
sensor to an official local weather station.
Rain gauge reports
rain when it is not
raining
An unstable mounting solution (sway in the mounting pole) may result
in the tipping bucket incorrectly incrementing rainfall. Make sure you
have a stable, level mounting solution.
Data not reporting to
Wunderground.com
1. Confirm your password or key is correct. It is the
password you registered on Wunderground.com. Your
Wunderground.com password cannot begin with a
non-alphanumeric character (a limitation of
Wundeground.com, not the station). Example, $oewkrf is not a
valid password, but oewkrf$ is valid.
2. Confirm your station ID is correct. The station ID is all caps,
and the most common issue is substituting an O for a 0 (or
visa versa). Example, KAZPHOEN11, not KAZPH0EN11
3. Make sure the date and time is correct on the console. If
incorrect, you may be reporting old data, not real time data.
4. Check your router firewall settings. The console sends data
via Port 80.
Specifications
Outdoor data