Operation Manual

- 13 -
Quick flash in every 2 seconds means failure communication between indoor/outdoor sensor and receiver
unit. Please check weather station and re-establish the RF communication.
z Power indicator: It flashes every 3 seconds during working.
Stop flashing means power failure. Please check battery.
7. Time and date will be synchronized with internet after start up.
8. Open the rubber seal on there is a RESET button beside the USB interface. Use a pen to click it can
reset the receiver unit.


USB Configure Tool Operation


Before using the weather station, you need to configure the settings on the PC via” WEATHER LOGGER”.
Receiver unit doesn’t have to be powered on during configuring, unless you need to check current weather
data and MIN/MAX records.
To download the latest “WEATHER LOGGER” PC software, please visit:
http://download.ecowitt.net/down/softwave?n=WeatherLogger
1. Decompress the Weather Logger file; open the Weather Logger Setup.exe to install the software.
2. Connect the receiver device to PC via an USB wire, and launch the software.
When base unit is connected to PC, it shows “USB Connected” at the bottom of screen. If no base station is
connected, it shows”USB Unconnected”.
All weather data will be displayed in table, if receiver grabs data from indoor sensor and outdoor sensor.