Operation Manual

work and supply power to outdoor unit (Figure 15)
The battery must be full charged before you set up the receiver unit. To charge the battery, Open the
rubber seal on USB interface and connect the receiver to PC or an USB charger via USB cable. Charge
the battery for at least 1 hour.



Figure15

4. Re-assemble the receiver and fix it on wall or vertical surface with flat wooden board. Please keep the side
with micro SD card slot and USB interface downward to make sure waterproof. If fix on wall directly, please
use an electrical drill to bore sizeable holes and insert the plastic inserts before you mount screws.
Figure16 

5. Mount the solar panel unit. Please mount it near the receiver for extending cable between solar unit and
receiver is only 5 meters. There are a metal holder,3 screws and 1 steel mounting loop included for solar
panel mount.
Mounting Steps:
a) Use a screw driver to assemble the metal holder on back of solar panel as shown in Figure 17.
b) There are 2 slots on the metal holder for steel loop. Attach the loop to the metal holder as shown in Figure 18.
c) Fix the loop on a mounting post and as shown in Figure 19. Make sure solar panel unit face sunlight.
d) Connecting the solar panel to receiver unit. A 5 meter extending cable is for option to extend the distance.
- 11 -