User's Guide

Page 3
channel number (the default is Channel 1), change Dip Switches 1, 2 and 3, as referenced in
Figure 3.
4. Temperature Units of Measure: To change the transmitter display units of measure (°F
vs. °C), change Dip Switch 4, as referenced in Figure 3.
Switch in down position. Switch in up position.
Figure 3
5. Insert two AA batteries.
6. Verify the correct channel number (CH) and temperature units of measure (°F vs. °C) are on
the display, as shown in Figure 4.
Figure 4
(1) temperature units (°F vs. °C)
(2) temperature
(3) channel number
7. Close the battery door.
8. Repeat for the additional remote transmitters, verifying each remote is on a different channel.
5. Sensor Placement
To mount or hang the sensor: