Setup Guide

16
If one WH57 sensor has been hooked on
GW1000 before, and you have a new WH57
sensor to replace the old one, just power off
the old sensor and power on the new sensor,
the gateway will pick up the new sensor data
automatically.
You may also go to the Sensor ID page of the
app (requires the Wi-Fi configuration done
first) to Re-register the sensor if not picked
up automatically.
5.2 Wi-Fi Connection for the Gateway
For this part, please refer to the manual of the
GW1000 Wi-Fi gateway.
Any question, please contact the customer
service.