User's Manual

① Light ON
② Light OFF
③ FAN Speed Control
④ Hi-Med-Low Speed circled automatically
⑤ Fan shutdown
⑥ Timing
⑦ Battery for transmitter (1.5V AAA*2, not include)
NOTICES:
1. If the remote can not control the ceiling fan lamp, please check:
a. Does receiver wired correctly? Do you hear “beep” at power on? If no, check wire
connection.
b. Does the remote indicator flick when you press any button? If no, check battery.
c. Are there any other remote control products nearby and working? Because remote
controlled products with the same frequency will disturb each other while working in
close range.
2. Please use this product under rated voltage. Too low voltage will lead to failure of the
operation. (Please refer to the product label for the voltage range and required
parameters)
3. Please remove the batteries from remote if you do not use this product for a long time.
4. Please keep the PULL CHAINS SWITCH at max speed and light on position before use
the remote control kit.
5. The antenna must be keep outside of the canopy
NOTE: Receiver and Remote are matched one by one in factory, it means one remote only control one
receiver. Following steps are the signal re-match method between remote and receiver if you want to
re-match in any conditions (please re-match in necessary):
Step1, Power on the receiver, one short “beep” from receiver.
Step2, Keep Press “Hi” + “ STOP” buttons in remote for about 3-5 seconds, Please note that the buttons
must be pressed in 5 seconds as receiver powered on (or less than 5 seconds). After 5 seconds, re-match
failure.
Step3, The lamp will flick 3 to 4 times, then match done.