Quick Start Guide

WARNING – When using this product, basic precautions
should always be followed, including the following:
a) Read all the instructions before using the product.
b) To reduce the risk of injury, close supervision is necessary
when the product is used near children.
c) Do not put fingers or hands into the product.
d) Use of an attachment not recommended or sold by power
pack manufacturer may result in a risk of fire, electric shock,
or injury to persons.
e) To reduce risk of damage to the electric plug and cord,
pull the plug rather than the cord when disconnecting the
power pack.
f) Do not use a battery pack or appliance that is damaged or
modified. Damaged or modified batteries may exhibit
unpredictable behavior resulting in fire, explosion or risk of
injury.
g) Do not operate the power pack with a damaged cord or
plug, or a damaged output cable.
h) Do not disassemble the power pack, take it to a qualified
service person when service or repair is required. Incorrect
reassembly may result in a risk of fire or electric shock.
i) To reduce the risk of electric shock, unplug the power pack
from the outlet before attempting any instructed servicing.
j) WARNING – RISK OF EXPLOSIVE GASES.
1)WORKING IN VICINITY OF A LITHIUM-ION BATTERY IS
DANGEROUS. BATTERIES GENERATE EXPLOSIVE GASES
DURING NORMAL BATTERY OPERATION. FOR THIS REASON,
IT IS OF THE UTMOST IMPORTANCE THAT YOU FOLLOW THE
INSTRUCTIONS EACH TIME YOU USE THE POWER PACK.
2) To reduce risk of battery explosion, follow these instruc-
tions and those published by battery manufacturer and
manufacturer of any equipment you intend to use in vicinity
of the battery. Review cautionary marking on these products
and on engine.
k) PERSONAL PRECAUTIONS
1) Consider having someone close enough by to come to
your aid when you work near a Lithium-ion battery.
2) Have plenty of fresh water and soap nearby in case battery
acid contacts skin, clothing, or eyes.
3) Wear complete eye protection and clothing protection.
Avoid touching eyes while working near battery.
4) If battery acid contacts skin or clothing, wash immediately
with soap and water. If acid enters eye, immediately flood
eye with running cold water for at least 10 minutes and get
medical attention immediately.
5) NEVER smoke or allow a spark or flame in vicinity of battery
or engine.
6) Be extra cautious to reduce risk of dropping a metal tool
onto battery. It might spark or short-circuit battery or other
electrical part that may cause explosion.
7) Remove personal metal items such as rings, bracelets,
necklaces, and watches when working with a Other battery
battery. A Other battery battery can produce a shortcircuit
current high enough to weld a ring or the like to metal,
causing a severe burn.
l) When charging the internal battery, work in a well ventilated
area and do not restrict ventilation in any way.
m) Under abusive conditions, liquid may be ejected from the
battery; avoid contact. If contact accidentally occurs, flush
with water. If liquid contacts eyes, additionally seek medical
help. Liquid ejected from the battery may cause irritation or
burns.
n) Do not expose a power pack to fire or excessive tempera-
ture. Exposure to fire or temperature above 60°C may cause
explosion. The temperature of 60°C can be replaced by the
temperature of 140°F.
o) Have servicing performed by a qualified repair person using
only identical replacement parts. This will ensure that the
safety of the product is maintained.
p) Attach output cables to a battery and chassis as indicated
below. Never allow the output clamps to touch one another.
1) Instructions shall include step by step directions for the
proper use of the booster function detailing the correct steps
to connect and disconnect the booster cables to
the battery.
1. Warning: Changes or modifications to this unit not
expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
2. NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference
by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit
different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician
for help.
IMPORTANT SAFETY INSTRUCTIONS
7. Only use safety equipment that has been approved by an
appropriate standards agency.Unapproved safety equipment
may not provide adequate protection. Eye protection must be
ANSI-approved and breathing protection must be NIOSH-ap-
proved for the specific hazards in the work area.
Service：Have your Power Hub serviced by a qualified repair
person using only identical replacement parts.
This will ensure that the safety of the Power Hub is maintained.
Flashlight Safety Warnings：
1. Do not shine directly into eyes of people or animals.
2. Not a toy; keep away from children.
3. Maintain labels and nameplates on the Power Hub. These
carry important safety information. If unreadable or missing,
contact Shenzhen Fenda Technology CO., Ltd.for a replace-
ment.
4. Avoid unintentional starting. Prepare to begin work before
turning on the Power Hub.
5. Do not leave the Power Hub unattended when the Battery
Pack is connected. Turn off the Power Hub, and remove the
Battery Pack before leaving.
6. The battery Charger gets hot during use. The Charger’s heat
can build up to unsafe levels and create a fire hazard if it does
not receive adequate ventilation,due to an electrical fault, or if
it is used in a hot environment. Do not place the Charger on a
IMPORTANT SAFETY INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS
LEGAL & COMPLIANCE
1. Keep Battery pack dry.
2. DO NOT DO ANY OF THE FOLLOWING TO THE BATTERY
PACK:
a. Open,
b. Drop,
c. Short-circuit,
d. puncture,
3. Charge Battery Pack only according to its Charger’s
instructions.
4. Inspect Battery Pack before every use;
do not use or charge if damaged.
LITHIUM BATTERIES STORE
A LARGE AMOUNT OF ENERGY AND
WILL VENT FIRE OR EXPLODE IF
MISTREATED:
flammable surface. Do not obstruct any vents on the Charger.
Especially avoid placing the charger on carpets and rugs;
they are not only flammable, but they also obstruct vents
under the charger. Place the Charger on a stable, solid,
nonflammable surface (such as a stable metal workbench or
concrete floor) at least 1 foot away from all flammable
objects, such as drapes or walls. Keep a fire extinguisher and
a smoke detector in the area.
Frequently monitor the Charger and Battery Pack while
charging.
7. This product is not a toy. Keep it out of reach of children.
8. People with pacemakers should consult their physician(s)
before use. Electromagnetic fields in close proximity to heart
pacemaker could cause pacemaker interference or pacemak-
er failure.
9. The warnings, precautions, and instructions discussed in
this instruction manual cannot cover all possible conditions
and situations that may occur. It must be understood by the
operator that common sense and caution are factors which
cannot be built into this product, but must be supplied by the
operator.
IMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS
e. Incinerate, or
f. Expose to temperatures
greater than 140°F.
SAVE THESE INSTRUCTIONS.
Lithium Battery Safety Warnings：
料号
PH2222
12.005.0004.05664
安规手册20220105
郭美娇 李莹
22年华盛顿PH2222蓝牙音箱
变更提出人 变更原因
项目名称
日期
包装工程师
设计版本
尺寸(mm)
材质
页码P数
颜色
表面处理
工艺
条码要求
装订方式
产品型号
部件名称
平面工程师
无条码
风琴折 线装 其它胶装骑马钉包心折
有条码（清晰易扫描）
说明书类说明：
1、公差（mm）：0<a≦50（+0.3/-0.2），
50<a≦150（+1/-0.5），>150
（+1.5/-1。有特殊要求的，按标示公
差执行。
2、要求图文清晰可辨，内容完整，折叠正确，
无重影，墨屎、杂点、脏点、异物、粉点、
套印不准。
3、尺寸按展开尺寸及成型外尺寸测量计算。
A0
10/p
展开570X108;成型95X108
80g书纸
单黑 正反面印刷
版本：A/4
PH2222安规手册
无
有：
是否有可参考
刀模
颜色
RoHS2.0、Reach
包装指令94/62/EC
大豆油墨印刷
无氯漂白工艺
粘合剂为非石油基
环保要求
油墨中禁止使用
矿物油（法国）
TPCH（美国）
光油 防刮花哑膜哑膜光胶UV油水性光油 水性哑油哑油
无 烫金 烫银 击凸 击凹 压网 其它局部UV
无
IMPORTANT SAFETY INSTRUCTIONS
Personal Safety；
1. Stay alert, watch what you are doing and use common
sense when operating a Power Hub. Do not use a Power Hub
while you are tired or under the influence of drugs, alcohol or
medication. A moment of inattention while operating Power
Hub may result in serious personal injury.
2. Use personal protective equipment. Always wear eye
protection. Protective equipment such as dust mask,
non-skid safety shoes, hard hat, or hearing protection used
for appropriate conditions will reduce personal injuries.
3. Prevent unintentional starting. Ensure the Trigger is in the
off-position before connecting to power source, picking up
or carrying the Power Hub. Carrying Power Hub with your
finger on the Trigger or energizing Power Hub that have the
Trigger on invites accidents
4. Do not overreach. Keep proper footing and balance at all
times. This enables better control of the Power Hub in
unexpected situations.
5. Dress properly. Do not wear loose clothing or jewelry. Keep
your hair, clothing and gloves away from moving parts. Loose
clothes, jewelry or long hair can be caught in moving parts.
6. If devices are provided for the connection of dust
extraction and collection facilities, ensure these are connect-
ed and properly used. Use of dust collection can reduce
dust-related hazards.
2) Each step shall be a different numbered item.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED
THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS MANUAL
AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER
OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRAN-
TY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALI-
FIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE
OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE
PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBU-
TOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS
REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND
LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE
BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF
HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR
REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR
HER INSTALLATION OF REPLACEMENT PARTS THERETO.
Electrical Safety
Do not expose Power Hub to rain or wet conditions.
Water entering a Power Hub will increase the risk of electric
shock.
IMPORTANT SAFETY INSTRUCTIONS
3. RF Exposure Statement
The device has been evaluated to meet general RF exposure
requirement. The device can be used in portable exposure
condition without restriction.
4. Rating Lable is located at the bottom of the product.
LEGAL & COMPLIANCE