Installation Instructions

Car Wireless Charger

车载手机支架无线充电器

Car Mobile phone holder

wireless charger

FCC Warning

This device complies with part 15 of the FCC Rules. Operation

is subject to the following two conditions:(1) This device may

not cause harmful interference, and (2) this device must

accept any interference received, including interference that

may cause undesired operation.

Any Changes or modiﬁcations not expressly approved by the

party responsible for compliance could void the user's

authority to operate the equipment.

This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to part 15 of the

FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential

installation. This equipment generates uses and can radiate

radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interfer-

ence to radio communications. However, there is no guarantee

that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the

equipment oﬀ and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit diﬀerent

from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for

help.

FCC RF exposure statement:

The equipment complies with FCC radiation exposure limits

set forth for an uncontrolled environment. This equipment

should be installed and operated with minimum distance

between 20cm the radiator your body.