Operating Instructions

Receiver MT-302RE Operating Instructions
Receiver’s Antenna Installation
Transmitter & Receiver LED Display
MT-302RE
Connects to the steering servo
Switch
Battery connector
Motor connector
LED Indicator
Antenna Wire
MT-303TX & MT-302RE Bind
Once the receiver LED stays
lit the binding is complete.
MT-302RE
MT-302RE
MT-302RE
MT-302RE
Step 1: Power off both transmitter
and receiver.
Step 2: Turn on receiver.
The LED indicator on the receiver
will begin to flash.
Step 3: Turn on the transmitter.
The transmitter and receiver will
now bind automitically within the
next 2 seconds.
LED ON: Connected
Rapid Flash: The singal is interrupted
Slow Flash: Low-voltage warning
LED OFF: Power off
LED ON: Connected
Rapid Flash: The singal is interrupted
Slow Flash: Low-voltage warning
LED OFF: Power off
Working Station Indicator
Working Station Indicator
CH3
Hi
CH2
Reverse
CH2CH1 CH3
N
N
R
RR
EPA
Lo
MT-302RE
MT-303RX