User's Manual

Document Name：APN0000241_V0.4.1_UDM06XX_User Manual_Excelland Service Robot 20220906
Document Security Level: Level 2
Doc.#: #: APN0000241_V0.4.1_UDM06XX_User Manual_Excelland Service Robot 20220906
Page 7 of 22
This Record Storage Period: Permanent
2. Charging
2.1 Placement of Charging Pile
The charging pile should be placed on the wall, and there should be no
other objects on either side of the center of the charging pile.
The charging pile shall be placed on flat ground instead of slopes or
carpets.
The height of the charging part of the charging pile should be consistent
with the height of the charging contact on the machine. Otherwise, the
bottom of the charging pile needs to be adjusted through appropriately
increasing or decreasing the filler.
The position of the charging pile should be fixed relative to the site to
avoid causing movement.
The distance between two machines shall not be less than 150cm when
several machines are used in the same scenario at the same time.
After placing the charging pile properly, connect the charging pile to the
power supply through the power line. At this point, the red indicator light
on the charging pile is on.
2.2 Manual Charging
Behind the charging pile are a one-meter manual charging cable and a
vertical cover connected to the right side of the machine. The cover is
fixed by magnetic suction. You can suck it out with the sucker
provided. After removing the cover, you can see the manual charging
port. Manually insert the plug at one end of the cable into the manual
charging port of the machine. After normal connection, the indicator light