User's Manual

Document Name：APN0000241_V0.4.1_UDM06XX_User Manual_Excelland Service Robot 20220906
Document Security Level: Level 2
Doc.#: #: APN0000241_V0.4.1_UDM06XX_User Manual_Excelland Service Robot 20220906
Page 21 of 22
This Record Storage Period: Permanent
9) Take photos, contact the technical support personnel, push the
robot back to the charging pile (starting point) and then restart it.
10) When the robot's path is blocked, if it can go around, the path will
be adjusted; if it can't go around, it will give a voice broadcast of
"Make way".
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance
20cm between the radiator & your body.
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
NOTE 1: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.