User's Manual

APN0000236_V0.3.1_UDL07XX_User Manual_Lora 20220728 Final Document level: 2
Doc.#: #: APN0000236_V0.3.1_UDL07XX_User Manual_Lora 20220728 Final
Page 20 of 22
This Record Storage Period: Permanent
3.3.7 Relay address
When the transmission distance between nodes is too far, this
parameter is set to the relay node’ ID, and the relay node will help
the node forward the data to the final destination node.
Default: 1000
3.3.8 Sleep mode
When the device is in low power mode, can be set to NONE(not
dormant), TIME(timing dormant) and DEEP(deep sleep). Regular
sleep, you need to configure the "wake up time" and "sleep time";
the depth of dormancy, only through the IO1 pin to wake up.
Default: NONE
In regular sleep, keep the device wake-up time, unit MS, when the
device wake up super this time will go to sleep.
In regular sleep, keep the device dormant time, unit MS, when the
device sleep over this time will wake up, in a normal working state.
3.3.9 Debug level
Debug level control module log display, can be divided into three
debugging levels, which:
0 do not output any log information
1 output Key log information
2 output detailed log information
Default: 1
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an