User's Manual

APN0000236_V0.3.1_UDL07XX_User Manual_Lora 20220728 Final Document level: 2
Doc.#: #: APN0000236_V0.3.1_UDL07XX_User Manual_Lora 20220728 Final
Page 17 of 22
This Record Storage Period: Permanent
For more details, refer to “AT command manual”.
Configure the UDL07XX parameters by configuration software, as shown
in Figure 3-2.
Figure 3-2 Configuration Interface
Column display serial parameters currently open serial port settings in the
serial port parameters,please choose the correct value of this configuration,
at the same time, open the serial port. The serial port parameter settings
column if the right button is displayed as "closed serial". That serial port
has been opened, otherwise please open the serial port.
The equipment again after power, configuration software UDL07XX into
the configuration state, and automatically load the current configuration
parameters of equipment, in the area on the right side of the display
parameters, thus can start all configuration parameters in the configuration
f8l10t, as shown in Figure 3-2.