Operating Description

15 Page / 16 Pages
1. Please pay attention to the input and output voltage range when using this product. The input voltage
and power range required by your device is not within the range of the energy storage power supply.
2. The connection cables must be matched, because different load cables correspond to different
equipment. Therefore, in order to normally use the energy storage power supply for your equipment,
please use the original connection cable 3 with guarantee.
3. The energy storage power supply needs to be stored in a dry environment. Proper storage method
can prolong the service life of the energy storage power supply.
4. If you do not use the product for a long time, please charge and discharge the product once a month
to improve the service life of the product.
5. Do not place the product in a place where the temperature is too high or too low
6. High or too low ambient temperature will shorten the service life of electronic products and seriously
damage the product shell
7. Do not use corrosive chemical solvent to wipe the product surface stains can be swab with a small
amount of anhydrous alcohol to scrub
8. Please handle the product gently when using, do not fall down or disassemble violently
9. There is high pressure in the product, do not disassemble by yourself, lest it may cause safety
accident
10. It is recommended that the device be fully charged for the first time to avoid inconvenience caused
by low power. After the device is fully charged, the fan will continue to work for 2-5 minutes after the
charging power cable is removed for standby heat dissipation (the specific time may vary with the scene
temperature)
11. When the fan is working, prevent dust particles or foreign matters from being inhaled into the device.
Otherwise, the device may be damaged.
12 After the discharge is terminated, the fan continues to work to lower the temperature of the device
to a proper temperature for about 30 minutes (the time may vary with the scene temperature). When
the current exceeds 15A or the temperature of the device is too high, the automatic power-off
protection is triggered.
13. During the charging and discharging process, connect the device to the charging and discharging
device properly before starting the charging and discharging device; otherwise, sparks may occur, which
is a normal phenomenon
1
Operating
Temperature
0-40
℃
1．Do not work in an environment higher than
40 ° C
2.It is recommended not to work in an
environment lower than 0℃
2
Storage
Temperature
-5-35
℃
Do not be used for a long time above 35 ℃
ambient temperature
3
relative humidity
20%－90%
4
Heat dissipation
Air
cooling
If the temperature of the product is too high, it will
work normally after cooling down