Service manual

www.enc.net.cn/en Tel/Fax:[phone] Run and operation explanation for inverter
39
3> Parameter protected. All the function code can’t be modified when function
code F2.13=1 or 2，in order to avoid wrong operation. Need to set the
function code F2.13 to 0 if you want to edit function code parameter.
(3) Specified frequency adjustment for common run
Take example modifying specified frequency from 50.00Hz to 40.00Hz at
F0.00=0 during running for explanation.
Fig. 4-8 set frequency adjustment operation example
(4) Jog run operation
For example, keypad as current run command channel, jog run frequency 5Hz,
waiting status.
Fig.4-9 Jog run operating example
(5) Operation for entering to function code editing status after setting user
password
“user password”FF.00 is set to“6886”. Boldfaced digit in Fig.4-7 shows
blinking bit.
Fig.4-10 inputting password to go into function code operation
0.0.0.6 6.0.0.6
0.0.0.0
50.00
0.0.0.6
6.8.0.6 6.0.0.66.8.8.6
-F0-
6.8.0.6
N
onediting
status
user passwor
d
effective, go into
password
validation status
At first last
Digit flash,
Increase to“6”
move cursor
position to
first digit
Increase
to“6”
Increase
to“8”
Increase
to“8”
Move to
second
digit
Press confirmation
Key, pass validation,
Go into editin
g
status
Move to third
digit
LED displayed
content
Key-press
operation
order
ENTER
DATA
SHIFT
ESC
MENU
SHIFT
SHIFT
5.00 50.00
0.0150.00
release
waiting
waiting
Display run
output frequency
Output
frequency
Increased by 5Hz
…
LED displayed
content
Key-press
operation
orde
r
Display
set frequency
p
ress
kee
p
Output frequency
Fall down to 0Hz
Stop running
0.01
REV
JOG
REV
JOG
REV
JOG
50.00 45.00 40.00
Press decreasing
button for one
time
Adjust frequency
based on
requirement
49.99
Stop pressing after set
value reached, go back
to normal display status
after 1 second
…
LED displayed
content
Key-press
operation
order