Service manual

www.enc.net.cn/en Tel/Fax:[phone] Run and operation explanation for inverter
34
4.2 Operation and use of key board
4.2.1 Keypad layout
Keypad is main unit for receiving command, displaying parameter. Outer
dimension of EN-KB6 is as Fig.4-2:
Fig.4-2 keypad layout sketch
4.2.2 Keypad function description
There are 8 key-presses and one adjusting button for analog potentiometer
on inverter Keypad and function definition of each key is as shown in table 4-1.
Table 4-1 keypad function table
key name Function description
Program/Exit key Enter into or exit programming state
Shift/Supervision
key
Can choose modification digit of set data under editor state；can
switch display status supervision parameter under other state.
Function/Data key Enter into the next menu or data confirmation
Rev/Jog key
Under keypad mode, to press this key can set reverse run or Jog
run according to the 2
nd
bit of parameter F0.03
Run key Enter into forward run under keypad mode
Stop/reset key
In common run status the inverter will be stopped according to set
mode after pressing this key if run command channel is set as
keypad stop effective mode. The inverter will be reset and resume
normal stop status after pressing this key when the inverter is in
malfunction status.
Frequency unit(Hz)
Current unit(A)
Reverse run indicator light
Forward run indicator light
Failure alarm indicator light
Mode indicator light
Rev/Jog key
Program, exit key
Stop, reset key
Run key
Shift/supervision
Confirm/data key
Analog potentiometer
Digital display (LED)
Data modification key
Voltage unit(V)
ESC
MENU
SHIFT
ENTER
DATA
REV
JOG
RUN
STOP
RESET