Service manual

www.enc.net.cn/en Tel/Fax:[phone] Appendix 2 The manual of EDS1300 middle frequency inverter
161
14: inverter ready to run (RDY)
15: inverter failure
16: traverse high and low limit restriction
17: interior counter reach final value
18: interior counter reach specified value
19: set run time arriving
20: interior timing arriving
21: reserved
22: reserved
23: reserved
24: reserved
F3.31 VCLanalog input gain 0-800% 100 ○
F4－Simple PLC function parameter group
Function
code
Name Set range
Min.
unit
factory
default
Modifi
-cation
F4.00 Simple PLC running setting
LED first bit:
0: no action
1: stop after single circulation
2: keep final value after single circulation
3: consecutive circulation
LED second bit:
0: start again from first section
1: continue to run at mid-section
frequency
LED third bit: PLC run time unit
0: second
1: minute
1 000 ×
F4.01 Section 1 setting
000－621
LED first bit: frequency setting
0: multisection freq. i (i=1~7)
1: freq. determined by F0.00 function
code
LED second bit: run direction selection
0: forward run
1: reverse run
2: determined by run command
LED third bit: Acc/Dec time selection
0: Acc/Dec time 1
1: Acc/Dec time 2
2: Acc/Dec time 3
3: Acc/Dec time 4
4: Acc/Dec time 5
5: Acc/Dec time 6
6: Acc/Dec time 7
1 000 ○
F4.02 Section 1 run time 0－6000.0 0.1 10.0 ○
F4.03 Section 2 setting 000－621 1 000 ○
F4.04 Section 2 run time 0－6000.0 0.1 10.0 ○
F4.05 Section 3 setting 000－621 1 000 ○
F4.06 Section 3 run time 0－6000.0 0.1 10.0 ○
F4.07 Section 4 setting 000－621 1 000 ○
F4.08 Section 4 run time 0－6000.0 0.1 10.0 ○
F4.09 Section 5 setting 000－621 1 000 ○
F4.10 Section 5 run time 0－6000.0 0.1 10.0 ○
F4.11 Section 6 setting 000－621 1 000 ○