Service manual

www.enc.net.cn/en Tel/Fax:[phone] Appendix 1 EDS1100 Drawing machine Inverter Manual
150
F1.08 DC brake voltage when stop running 0 6
F2.00 Analog filter time constant 0.20s 0.03
F2.18 Acce. time 2(when start up smoothly ) 20.0 150.0
F2.19 Dece. time 2(when start up smoothly ) 20.0 150.0
F2.21
Interval time 1of retracting volume diameter
calculation
500ms 300
F2.22 Empty diameter gain(retracting and releasing gain) 100.0 40.0
F2.23 PID adjustor gain 30.0 30.0
F2.24 Start-up volume diameter calculation gain selection 0 0
F2.25
Start-up volume diameter calculation gain(volume
diameter calculation gain 4)
2.0 1.0
F2.26 Volume diameter calculation gain 3 0.4 0.4
F2.27 Volume diameter calculation gain 2 0.0 0.0
F2.28 Volume diameter calculation gain 1 0.0 0.0
F2.29 High limit of retracting volume gain 200.0 100.0
F2.30 Start-up retracting and releasing gain control 1 1
F2.31 Retracting and releasing speed gain +/- control 0 0
F2.32 Retracting and releasing recombination control 0 0
F2.33
Interval time 0of retracting volume diameter
calculation
800 800
F2.34
Dead zone of retracting volume diameter
calculation
0.10 0.10
F2.35 Range 1of retracting volume diameter calculation 0.70 0.70
F2.36 Range 2 of retracting volume diameter calculation 1.20 1.20
F2.37 Range 3 of retracting volume diameter calculation 1.70 1.70
F2.38 Range 4 of retracting volume diameter calculation 2.20 2.20
F2.39 Time of starting up smoothly 2000 2000
F2.40 Start up PID again control 1 1
F2.41 Start up PID smoothly selection 1 1
F2.42 Volume reset control 0 0
F2.43 Wire disconnecting delay PID control 1 1
F2.44 Time of wire disconnecting delay 5000 5000
F3.00 Closed-loop run 0 1
F3.08 proportion gain KP 0.250 0.800
F3.09 KI Integral gain KI 0.010 0.010
F3.12 Deviation margin 1.0(%) 1.0
F3.20 PID proportion gain 2 0.300 1.000
F3.21 PID Integral gain 2 0.000 0.000
F3.22 PID parameter self adjustment basis 1 1
F3.30 Failure relayTA,TB, TCfunction selection 15 15
F5.01 Input terminal X2 function selection 0 11