Service manual

www.enc.net.cn/en Tel/Fax:[phone] Appendix 1 EDS1100 Drawing machine Inverter Manual
149
6.1 Parameters setting reference of big and medium type drawing
machine
6.1.1 Host parameters of big and medium drawing machine （EDS1000
Series）
Function Code Function Name Factory Value Setting
F0.00 Frequency input channel selection 1 4
F0.02 Run command channel selection 0 1
F0.08 Acceleration time 1 20.0 40.0-60.0
F0.09 Deceleration time 1 20.0 40.0-60.0
F0.10 Upper limit Frequency 50.00Hz 80.00
F0.14 Torque boost 0.5 1.0
F2.06 Jog run frequency 5.00Hz 6.00
F2.07 Jog acceleration time 20.0s 6.0
F2.08 Jog deceleration time 20.0s 6.0
F3.30 Failure relayTA,TB, TCfunction selection 15 15
F5.00 Input terminal X1 function selection 0 11
F5.01 Input terminal X2 function selection 0 5
F5.02 Input terminal X3 function selection 0 12
F5.10
Open circuit collector output terminal OCI
Output setting
0 2
F5.15 FDT1(frequency level)electric level 10.00Hz 4.00
F5.16 FDT1 lag 1.00Hz 0.01
F5.17 Analog output (AO1)selection 0 0
F5.18 Analog output (AO1)gain 1.00 1.00
F5.19 Analog output (AO1)offset 0.00 0.00
F5.20 Analog output (AO2) selection 0 0
F5.21 Analog output (AO2) gain 1.00 1.00
F5.22 Analog output (AO2) offset 0.00 0.00
F7.03 VCI max. provision corresponding freq. 50.00 80.00
6.1.2 Wire receiving machine parameters of big and medium drawing
machine （EDS1000 Series）
Function Code Function Name Factory Value Setting
F0.02 Run command channel selection 0 1
F0.03 Run direction setting 000 010
F0.08 Acceleration time 1 20.0 2.0
F0.09 Deceleration time 1 20.0 2.0
F0.10 Upper limit Frequency 50.00Hz 75.00
F1.05 Stop mode 0 2
F1.06 DC brake initiative freq. when stop running 0.00 2.60
F1.07 DC brake time when stop running 0.0 1.5