Service manual

www.enc.net.cn/en Tel/Fax:[phone] Appendix 1 EDS1100 Drawing machine Inverter Manual
145
F3.30
Failure relay
TA,TB,TC
function selection
0：inverter running（RUN）
1：frequency arriving signal（FAR）
2：frequency level detecting signal（FDT1）
3：reserved
4：Over load warning alarm signal（OL）
5：Output frequency reach high limit
（FHL）
6：Output frequency reach low limit（FLL）
7：inverter under voltage blockage stop (LU)
8：external failure stop running （EXT）
9： inverter zero speed running
10：PLC running
11：simple PLC section running finished
12：PLC finish a cycle running
13：reserved
14：inverter ready to run (RDY)
15：inverter malfunction
16：Swing frequency high and low limit
restriction
17：interior counter reach final value
18：interior counter reach specified value
19：set run time arriving
20：interior timing arriving
21：reserved
22：reserved
23：
reserved
24：reserved
15 ○
F5－Terminal correlative function parameter group
Function
code
Name Set range Unit
Factory
default
Modifica
tion
F5.00
Input terminal X1 function
selection
31：Run command channel selection 3
32：Swing frequency jump-in
33：External interruption input
34: Interior counter reset end
35：Interior counter triggering end
36：Interior timer reset end
37：Interior timer triggering end
38：Pulse frequency input（Only effective for
X7,X8）
39：Reserved
40：Reserved
41：Reserved
42：Reserved
1 0 ×
F5.01
Input terminal X2 function
selection
Same as above
F5.02
Input terminal X3 function
selection
Same as above